Multistops, i.e. multiple loading and unloading locations, can only be added when you add a single loading space to the project. It is not possible to set points along the route for multiple semi-trailers or containers.
- To add multistops, go to the Loaded space tab.
- Choose a loaded space from the list or enter its dimensions manually.
- Click on Points along the route.
- If you plan to have more than 3 points along the route, click Add another point.
- Add the name of the starting point, intermediate point and the end point.
- Multistops can be added for a minimum of 3 points. If you have more than 3 points, you will see an option to remove one of them.
- Click Save when you finish setting up the points along the route.
If all the information about the loaded space has been filled in, click Add.
Next, when adding loads, it is necessary to indicate the loading or unloading location, which we have described in detail in this module.
- All the locations on the route, along with the loads to be loaded or unloaded, are listed.
- After clicking on a specific point on the route, you can see a visualization of the loaded space corresponding to a given location.
- If any load is to be unloaded at a particular point, it appears in a red space outside the semi-trailer or container.
