Centre of gravity of load

The load center of gravity should be used together with the enabled center of gravity in sea containers. Therefore, before adding the load center of gravity, set the container’s center of gravity.

By default, the centre of gravity for a load is set in its centre. You can change its position, but only for cubic loads.

1. If you want to change this setting, go to the centre of Gravity tab.
2. Check the Display centre of gravity option.
3. Adjust the position of the centre of gravity along the X, Y, and Z axis.
4. You can preview the location of the centre of gravity in the visualization.
5. If you have filled in all the load information, click Add.

Check also:

• Stack
• Rotate
• Loading place
• Arranging loads at an angle